Suspension-Front and Rear

Wheel bearing as fitted to the Noble M12, GTO-3, GTO-3R and M400. This bearing is universal to the front and rear - 4 per car.

Ball joint fitted to the front lower suspension on the Noble M12 and M600. These ball joints may need lathing down to 49.2mm.

Steering Tie Rod fitted to the Noble M12, GTO, GTO-3R and M400. The overall length is 305mm and the rod length is 260mm. This is the only Steering Tie Road we are able to supply.

Set of dampers and springs specially made for the Noble M12-GTO 3R and M400. The spring rating is 600lbs on the front and 700lbs on the rear.

GAZ Monotube is a new quality damper to satisfy the needs of the discerning competition and track day enthusiasts. Built from high tensile alloy to withstand the high stresses that are involved in race conditions. The damper body is hard anodised to give maximum protection against wear during use. Bump and rebound are on the car adjustable by a single adjuster on the rod and the unit is charged with an inert gas via an internal floating piston. PTFE lined sperical bearings are used for the end fittings to give a smooth quiet mounting of the unit.

These are a special order part and the lead time is normally 3 weeks.

Front coil spring as fitted to the shock absorber on the Noble M12, M12 GTO-3, M12 GTO-3R and M400. These should be fitted in pairs.

Rear shock absorber, original Bilstein, as fitted to the Noble M12 2.5, M12 GTO-3, M12GTO-3R. Two per car required.

Front Upright Assembly, left hand side, as fitted to the Noble M12, GTO-3, GTO-3R and M400. One per car, requires the following extra part to fit - M12SUS02 Wheel Bearing

This bush fits the wishbones and also the rear suspension upper arm on the Noble M12 [all models]. Also fitted to Noble M400 and M600.

Lower Rear Wishbone, right hand and left hand, as fitted the Noble M400 and all 6-speed cars. Each wishbone requires 3 bushes - M12SUS18.

Rear, right hand Track Control Arm as fitted to the Noble M12.

Rear Upright Assembly, right hand side, as fitted to the Noble M12, GTO-3, GTO-3R and M400. One per car. requires a hub M12SUS55 and M12SUS02 Wheel Bearing.

The photograph shows a hub and bearing fitted which are extra to this part.

Neoprene Suspension Washers as fitted to the Noble M12, all models, M400 and the M600. Requires 16 on the front suspension and 24 on the rear suspension of the M12 and M400 models. Dimensions: 41mm OD, 20mm ID, 2mm Thickness. This replaces part number M12SUS37.

Top Rear Wishbone, right hand, as fitted to the Noble M12 [later models].